💡 Glo Brite by 21st Century L25P: The Ultimate Standard Brass Lamp Burner for Enhanced Illumination Review

I thought I had a defective product so I ordered a replacement. The same problem when replacing - ordinary oil lamps will not fit.

I bought this to replace the bulb for my vintage oil lamp that I've had for probably thirty years. It doesn't fit and I can't find a replacement for the old one that was damaged. I bought one and the other the same size and they both don't fit. Discouraging.

The block is made abroad and they claim it's a standard base but it's two thousand inches off. Doesn't sound like much until you put it on an American antique glass stand. Fit, but I had to adjust the threads on the lid part.

Even when I ordered the correct size, the threads were not compatible with any of the (otherwise standard) oil lamps I own (and have an assortment of). If you have standard glass oil lamps, this probably won't work.

This item doesn't fit my oil lamp. I thought it was a standard size but it was too small to screw onto the lamp. I just replaced the globe and burner with my other lamp and the burner fitted perfectly so I figured I could order a new burner for this one too. I just took out the wick and continued to use the old burner.

had to be returned. older lamps are threaded on the inside of the "neck". This is done for the threads on the outside of the lamp neck. very nice, but not suitable for my lamp. Be sure to check the threads before ordering as the product information does not describe the thread location.

The lamp looked good and the dimensions were correct, but the sockets do not screw into the base of the lamp as the grooves do not match. I've tried it on 3 different oil lamps and it hasn't screwed into any of them, although it looks like it should fit. I will look for another provider. This product should get less than one star as it is useless to me.

The base as in the photo is different from what was sent then sent back. The base where the block screws onto the lamp resembles a bottle cap or wide-mouth jar with threads on the inside of the lid. The diameter didn't matter, so I didn't measure it. If it was like the picture, it would have a better rating. (5 months later) I bought a burner at a hardware store that looked like the one they sent me. The packaging said the base would detach from the top. When I removed the base the top looked…