🏍️ SUNPIE 7-inch Chrome Round Headlight Mounting Bracket for Harley Motorcycle Headlight Review

If you are purchasing a 7" Sunpie LED Headlight for your Harley Davidson you will need this trim ring to complete the installation 2013 Harley Switchback (FLD) --- Can't say for sure on other models, but it makes sense that all Harley installations would require it.

Bought on recommendation of a seller who sold me a defective LED Halo on a Revain... The light was not working properly and this bracket was not needed , because the 7" light fits my original mount perfectly... It looks like a well made mount for those who need to mount a 7" light, but there is no 7" mount already installed from the factory .I give it a low rating.a point because I don't need it and it was recommended to get it but it can't be returned...thank you.

Overall, this product is worth the money. The only problem I had was that I couldn't put my trim ring (aka trim ring, aka headlight flap) back on without going to the store and buying a $.70 nut. (Reference Dorman #961-298) Also, as mentioned here, I recommend turning the adjustment screws in a few turns. The rest of the installation is very easy, requiring only a couple of screwdrivers and an Allen key. There is no need to remove the fairing or any other item from your bike. I installed it…

This part is required to properly install the Harley Sunpie LED Headlight. After trying to cut the stock bracket/bowl to fit the headlight like some of the other reviewers who posted on the headlight, I gave up and ordered this one. I had to adjust some things. It's okay because you still don't see it. Easy installation. Fits perfectly. I used this on a 2011 Ultra Limited. My bike already had a large, oversized chrome trim ring, but I think it would probably still look good without it. I wish I

2004 Road King. Attaches perfectly to the headlight housing. The light went into the holder normally. I had to spend time adjusting the position of the bottom screw plate to tighten the retaining screw. Once the outer ring of the bezel was loosened. Shown at left is a SunPie mount. You can see the gap. There was a gap of just under 1/4 inch all around. I heard it rattling while driving. Replaced it with a mount bought from a local dealer. Now it fits perfectly. The photo on the right is the…