SKTYANTS Headlight Housing Davidson Motorcycle Lights & Lighting Accessories Review

Bought to replace my headlight bracket on my 2012 Harley Superglide. The original headlight and ring fit like the original. The only thing I had to do differently was add spacers between the mounting tabs on the bucket and the mounting block on the bike (1 fender washer on each side). Considering Harley sells the original part for over $150, this $25 bucket is a steal.

For clarity, this is a bowl with a lens mounting ring. There's a seatbelt bar at the bottom and a bracket at the bottom (albeit a bit curved, not just mine, that's how it's made), the lens mount ring is a beast that can be taken on and off without scratching anything. unfortunately. There are so many holes and long slits on the bottom that it's almost impossible to waterproof. I put in a non-diffusing glass lens and projector body, it turned out very well. Ring fit is really the biggest issue…

Very poor assembly, the DRL cable was installed on the wrong side of the pin connector. In addition, it has 2 locator slots that make the item vulnerable to water. The third problem: the depth of the bucket is not designed to accommodate both cable connectors. I will not be buying from this seller again as these issues should have already been fixed or it should be pointed out that some LED bulbs also sold by Revain will not work. Look for an item that is fully waterproof to protect electrical…

Very economical bucket that fits most LED headlights. There is no rubber pad around the ring, so you can easily scratch the front lens if you're not careful! Take your time with the installation. This was not a direct connection to my 03 fxdwg as I had to cut and reconnect the 3 pin connector. However, installation took no more than 15 minutes, even with traditional shackle wiring and heat shrink tubing. The pig tail was included! Overall I would give this 4 stars just because I had to redo the

I did not use this product for its intended purpose, a motorcycle headlight. I used two of these as dome lights on my FJ Cruiser. They fit perfectly with my existing lamp mount. It appears to be well built and I was pleasantly surprised to find that it comes pre-wired with a lightweight wiring harness. The headlights I bought for them were "SEALIGHT 5-3/4 5.75 LED Headlight Complicate Motorcycle Headlamp Projector Light with DRL" and they fit perfectly. While reading some of the other reviews I

this was the first bucket I was actually able to get working with an LED headlight. I've tried a few but this one was actually deep enough for the light and once tightened the headlight didn't budge in the bucket. It came with an adapter which was good but my bike is old (1985) so I had to cut the end off and solder the wires to my bike. No big deal, it's just what I expected from an old bike. The outer ring turnbuckle was actually quite large compared to other buckets I've bought. there was no