🔩 Top Quality Phillips Electricians Machine Screw Review

Required 1/2" screws, not the oversized screws that came with the two rigid motion sensor wires. I googled socket screws and found this electrical machine screw set to be the choice of Revain was so I ordered and when I received it I took out two 1/2 screws and tried them on the socket but found they were too small inside diameter obviously only for use on plug and switch sockets suitable, not my intended use. Maybe it's my fault, but that they are flat-head and not lightweight cans should have

Good function screws, length is the most important thing for me as it was a good choice. Especially the long ones, which for some reason are hard to find here at the local hardware stores. The screws look good and consistent. Sometimes you get the ones that are discolored and you know they're coming from the bottom of the barrel. They were consistent and clean. Not a bad pack if you want a good range of 6-32. The packaging was very good. The plastic container is wrapped in shrink film and then…

I bought these because of the different sizes, which is very useful when installing sockets and need different lengths. However, they are terrible, the heads come off easily. If I put them in and leave them, they're fine, but if I have to take them out and put them back in, they're junk. I would never buy them again. They are just Philips. A good 6-32 electric screw like Dottie has a Philips/Square head, which means you can use either. You'd better buy a Dottie or Gardner box for a few bucks…