Pulaski Home Comfort Mid Century Modern Accent Chair - Neutral Chestnut, 25" X 28" X 30.5 Review

At first I thought this was a great item, very easy to assemble. Then I tried to attach the stretcher, which looks like it is important for the strength and stability of the chair. I was sure I was doing something wrong, but couldn’t figure out why, so I put the pieces back in the box and waited a few weeks until I felt a little better health-wise. Today I pulled it out to see what was up, and found that the holes in the stretcher and legs do NOT line up when the seat is in place. It looks like

I love these chairs! I bought two. They are very comfortable and sturdy. They support my weight well (300+ lbs) and look great! The only issue I've had is that some of the the little caps that go over the screws have popped off. I would glue them on when you assemble it and keep the spares incase you lose one.

Here’s the deal. this chair isn’t perfect. There were a few blemishes upon unpacking and it does require some assembly BUT I really don’t see how you can beat the price. Similar looking (albeit higher quality) chairs go for $500 on west elm and frankly from a distance look essentially the same. I put it in my living room and get tons of compliments.

I’ve put together many of these types of chairs and these were by far the most difficult. Hard to get the holes lined up. Make sure to not fully tighten screws until it’s basically connected. Even when doing this is still tough. Looks great though and comfy.

The price I got on this was great. (MUCH better than the same item on rip off non-returnable unless you PAY, WayFair). It shipped very quick. The fabric has a bit more texture to it than I would have liked, but it is still nice. The seat cushion is mostly wire/spring, accessible underneath and seen when you unzip the bottom fabric to find the assembly hardware. But it does have bounce to it with some cushioning. I'd guess perhaps 1 or 2 inches of foam on top of the springs.Where it gets tricky…

Good chair: nice looking and comfortable. I use it at a desk near a heater, and the dry heat caused one of the pre-fabricated joints to pull apart, probably because the chair was originally made from wood that was still slightly green and shrinking. I used wood glue and bound the legs for several hours and this fixed it, but this isn’t part of regular assembly.

It looks great! My only issue is that the holes didn’t align on the final piece (the horizontal board below the seat). It’s held up by the pressure, but no screws were put in. Directions were fairly clear but it got a little confusing towards the end.

I think it's great. It is very comfortable and I like the way it looks.One note is yes it wasn't the easiest piece of furniture to put together but in order for it to be sturdy and rigid it shouldn't be. It is over constrained but this leads to a sturdy comfy chair. Once you build it you will like it.

These chairs are very stylish, the finish on the wood was poorly done, my husband actually sanded them down and refinished to match our furniture.

The chair looks nice and is pretty sturdy. For $150 its a decently made chair.My problem with it is the back cushion. Its not a cushion, its just a spring. There is a bit of padding on the top of the chair, but the main section, where most of you back comes in contact, is just a basic spring and it provides no support.I don't really want the chair, but returning it seems like a massive hassle.

Was thrown off by the color- I thought it would be more brown colored but has blue and purple stitching. Had a very difficult time putting together, had to use a lot of force to get pieces to fit right. Not comfortable but got better and more worn in over time.

This is perfect for my tiny house Airbnb! There are alignment issues with the stretcher. Otherwise a good value for $110.00 (Ebay warehouse)