Header banner
Revain logoHome Page
πŸ”— 305-610 heavy duty stainless steel cb antenna stud by wilson antenna logo

πŸ”— 305-610 Heavy Duty Stainless Steel CB Antenna Stud by Wilson Antenna Review

3

Β·

Average

Revainrating 3 out of 5Β Β 
RatingΒ 
3.0
πŸ“‘ Heavy Duty Fleet Navigation & Communication Supplies, 🚚 Heavy Duty & Commercial Vehicle Equipment

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”— 305-610 Heavy Duty Stainless Steel CB Antenna Stud by Wilson Antenna
img 2 attached to πŸ”— 305-610 Heavy Duty Stainless Steel CB Antenna Stud by Wilson Antenna
img 3 attached to πŸ”— 305-610 Heavy Duty Stainless Steel CB Antenna Stud by Wilson Antenna
img 4 attached to πŸ”— 305-610 Heavy Duty Stainless Steel CB Antenna Stud by Wilson Antenna

Description of πŸ”— 305-610 Heavy Duty Stainless Steel CB Antenna Stud by Wilson Antenna

Made of heavy-duty stainless steel. Compatible with Wilson 305-610 antenna. Designed for roof & other flat surface applications. Perfect replacement stud for larger antenna applications.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

You need that instead of the ### cheap junk at the truck stop.

Good solid antenna mount. Much better than the standard hex adapter that you pull the center out of when it never seems to tighten. Even better than Wilson's lollipops. Solid stainless steel. good piece Get one.

Pros
  • Absolutely amazing!
Cons
  • Quality

Revainrating 1 out of 5

Don't buy them but they look very nice

Why? Who could design this so that it doesn't touch the pl259 connector. Haven't done it since then. If you buy this plan, make one change to make it work. For example, solder a pl259 tip so it can make contact. Just attempted to install today, finally put back the originals supplied by Kenworth.

Pros
  • Sturdy construction
Cons
  • -

Revainrating 3 out of 5

UPDATE: September 2015 - Rating changed from 1 star to 3 stars - Still (very bad technical design)

The interior of the bolt is poorly designed. The PL-259 connector does not make contact with the inside of the base. In general, the hairpin is very strong, but it is useless because the coaxial cable does not make contact. I'll try re-soldering the end of the coax cable and see if I can get it to make contact with the inside of the stud. works well. I am adding two stars because the bobby pin works now and is very heavy. I can't give more than three stars because the PL-259 connector is…

Pros
  • Alright!
Cons
  • Some difficulties