🔊 AIYIMA Updated Version 2 Way Adjustable Multi Speaker Treble/Bass Crossover Filters - 1pc 400W Audio Frequency Divider with 2 Units Review

I wish they would post specific frequency abbreviations with different jumper combinations. The instructions/explanations I found are approximate and the only reason I need a crossover is to optimize frequency distribution. Just because something sounds good doesn't mean it's performing in its ideal range. In addition, the sound quality is ok.

I have a MICCA center channel it's amazing but no crossover (shame on you Mikka). I put that in and adjusted the jumpers and it woke the speaker up! Clean highs, good lows. I will say that the writing on the board is in Chinese, so that's a problem, but after trying the combinations in the pictures, I quickly found the right tones. I use it in a 100 watt setup with two woofers and one tweeter. For 12.50 you will like the sound very much. I'm thinking of making some custom speakers and I'll go…

I read somewhere that the board is weak. Actually a good board. The PCB is thick and it is a good quality board. What I really struggled with was the cable connections. It's a good concept but the connectors are too flimsy/weak so they don't hold the cables well, especially if the cable is a bit thick like a subwoofer cable. You can only hold a small wire, and even then, tightening the screws with a flathead screwdriver will result in the entire plastic connector body popping out. I had to use…