Honda M77 HN 08798-9010 Moly Paste Review

Great product for BMW R1200GSA driveshaft lubrication, took me a while to get it but very satisfied, good price too, definitely recommend

Need higher pressure protection and less spatter. I added a small amount of molybdenum to the paste, which both thickens it and provides a neat protection for the drive splines.

I bought two tubes of this molybdenum paste. Squeezing the paste out of both tubes was difficult and squeezing the tube resulted in leakage through the bottom. Coat the teeth of my BMW R1200GSA final drive with it. I double checked the splines and the paste stayed in place.

I thought "holy cow is a small tube of lube for so much money!". But I've found that, like many other reviewers, this is not only what my Honda recommends for saving on splines (which are a lot more expensive than grease), but also that you're not really using a lot of it every time. I think this little tube will last me a few years.

If you have a drive shaft bike and you work with it yourself, you're going to need some of this at some point. This is a high quality molybdenum paste. The consistency is more like fat. The only complaint is that it comes in a small tube for a grease gun and not the squeeze tube shown in the picture. Just make sure you wear rubber gloves when using this material. it doesn't wash off.

Will Revain Ebay? The item I received was sealed with an old barcode and did not look like the photos. Maybe it's real but I still feel cheated, it's not real Honda and not made by Honda. It's made by PolySi Technologies, probably for Honda. As far as I know it's hand lotion. I will buy another molybdenum paste in the future.

This is an excellent molybdenum paste that can be used for many purposes. I mainly use it to apply to the back of the brake pads. The manufacturer supplies a set of brake pads, but they have been saving on them lately. Used for all vehicle makes and models, not just Honda. An excellent molybdenum paste that can be quickly resealed and reused for a variety of purposes.

This is a Honda M-77 assembly paste with a completely different formulation than the Honda Moly 60. It comes in a 2.65 ounce plastic tube, not in the illustrated tube of grease. . The part number given in the product title is incorrect and instead of promoting the correct product, they decided to change the part number in the product description, hoping that we stupid consumers wouldn't notice. Well it worked, but I get my $16 back.

I have a Weatherby Vanguard 270 Winchester and the trigger pull to fire the rifle was 3 sharp pulls. I was ready to replace the trigger but read about using molybdenum paste to repair sandy triggers. I removed the trigger and lubricated the sliding surfaces of the trigger and trigger bar with molybdenum sliding surface paste. This completely eliminates the gritty feel and the trigger is now great. Saved me from changing the trigger.