I have two old Ford trucks with just over 400k miles and one with just under 300k. I've gone through several ball joints over the years. I've always used Moog. I seem to get around 70k to 90k miles before they start to get a little sloppier than I prefer. I usually replace the top and bottom and usually replace both sides at the same time. the only thing i noticed is that if you loosen the preload on the ball joints in the workshop, their service life is drastically reduced. like cutting it in half. so after installing new ball joints I don't align the front end. I have always been satisfied with Moog products. and would recommend her to anyone. Yes I think I will use the same lettering on the upper ball joint
π§ 1320 Performance Stainless Steel Coilover Spanner Wrench Set - 3PCS for Easy Adjustments
9 Review
π§ OEMTOOLS 27308 Ball Joint Separator: Adjustable from 1-1/8" to 2-1/8", Perfect for Common Ball Joint Sizes, Enhanced Steel Separator Mechanism with Black Oxide Pins
9 Review
OEMTOOLS 24429 Ford 3-Valve Spring Compressor: Efficient Tool for Ford Valve Spring Compression
9 Review
Enhance Your Truck's Power with OrionMotorTech Heavy Removal Adapters
8 Review