Review on 🔧 Semi-Automatic Adhesive Dispenser Controller for Efficient Operations by Adam Hardy

Failed to load media. Heated the end of the included hose and connected the existing manifold quick connector that came with my gray airbrush to a 600 heat gun placing the hose over it for about 10 seconds. It's the perfect fit. Without heating, the hose will not be plugged onto the male end. Haven't used the car yet. I'm still figuring out how to remove the part that pushes the product down. And as I type this I think I'll have to use the vacuum function to get it out. It worked by putting the part that normally goes to the back of the syringe to the front of the syringe without the needle pushing it up. The test water is pushed out unevenly, but I suspect this could be due to the on-demand compressor system used by Grex.