Review on Hitachi HPP0004 High Pressure Fuel by Matthew Sytniak

Please read before ordering or asking questions. ! Suitable for Audi 2.0T FSI and VW TFSI engines (approx. 2005.5 to 2009). Please do your own research, open the hood and see if it looks the same. An early pump has a banjo fitting. This pump is FULLY compatible with this pump. All you have to do is remove the fitting from the old pump and replace it with the fitting from the new pump. Also, early cars do NOT have a pressure relief valve, but this pump has a fitting for one. Don't waste your money and buy it. Just take a small screw plug and crush the washer. (top tip) Install one of your long torx screws before inserting the connector as it will now be pinched when the head hits the connector. ) The pressure sensor is built into the end of the pump shown in the picture, but there is another sensor that screws into the top, it is not included and you will receive what you see in the picture. Again, no big deal, just swap. the details are over. You will probably need a new cam follower which is not included but the pump seal is as shown in the fig. Good luck mine has been working great for almost 3 years now. Hitachi is the original pump that comes with your car. Much luck.