Review on 🔳 Waterproof Stainless Steel Momentary Pushbutton Switch by DaierTek by Dushawn Walker

I tried running solder wires to 3 of them. I'm not sure what's going on inside, but every time the switch gets stuck in the closed position after soldering. I'm not new to soldering. I thought maybe I put too much heat on the iron for too long. So I was very careful with attempt number 3. The result is the same. The button works as expected, but the internal switch is stuck in the ON position. The other 3 are thrown in the trash. Don't waste your time with this if you plan on soldering wires to these switches. Maybe a tiny spade would be fine, but why risk something so low?