Review on 🏍️ USA Motorcycle Crash Bar for Yamaha MT-09 FZ-09 XSR900 Tracer 900 - Steel Engine Guard Bumper for Fuel Tank Protection (Black) by Tim Nicholas

The parts are good, fit the bike well enough for the bolts to be aligned with minimal effort. The front studs for my 2014 fz-09 are too long. The 80mm screws for the top are the correct length for both the top and the front. Now I have to go to the hardware store and hopefully find a suitable replacement. There are no correct instructions or markings on the screws. Just a picture with three marked locations for screws. The subframe is good. I had to use some shims to make room to keep the brake fluid reservoir from rubbing. I would buy again for the price. The paint was damaged when unpacked. Edited, downgraded to two stars only because the lower cross member doesn't clean my Acropowich exhaust. Now you need to either reset it or try bending the crossbar and adding shims to make up for the lost length of the bends. Might fit the stock exhaust. Oh yeah and the staff trying to figure out what was wrong ie the length of the bolt resulted in one of the lugs on my motor being on the right, totally my fault but if the correct bolts were included this problem wouldn't arise have been caused.