Minivan with 3.8L engine? JUST DON'T. Take my hard-earned advice: just go to the dealer. It's anything but simple and easy. To access the PCV valve, you must remove the wipers, motor, and wiper arms. If possible, you should probably remove the hood as well. The original is mounted in a plastic valve cover on the back of the engine. It is almost impossible to remove the original from the valve cover without damaging the plastic holder it is housed in. Seriously, it looks like it's welded to the valve cover. I know someone who pulled it out, but it took hours to gently pry the rubber seals out and probably left crumbs in the valve cover. Chemicals are no good because you don't want them in the valve cover either. This design is bad, the worst. There isn't enough pressure inside the valve cover to justify this ridiculous design. Also, there's no reason why it couldn't be installed on the front valve cover.
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review