Review on 🛁 KES Bathroom Hotel Bath Towel Rack with Double Towel Bar - 23.3-Inch Wall Mount Shelf, Stainless Steel, Rustproof, Modern Brushed Finish - A2112S60-2 by Tammy Kaiser

I like it very much, well made and looks very nice. Don't use the included screws though (they aren't strong enough if you're actually going to be attaching a lot of things to them). I'd downvote it for that, but I'm not aware of any rack that actually comes with heavy-duty mounting hardware. A few installation tips: 1. If you can, attach one side to one of the 2 x 4 studs. I used a stud finder, marked its location and installed so that only one side was built into the drywall only.2. The mounting plate can be installed with vertical or horizontal holes. In the block it is delivered horizontally. The vertical is stronger and easier to install in 2x4 so I used vertical.3. I used a reinforced drywall mount (100lbs) on top and a much simpler one (50lbs on the bottom hole). Surprisingly strong. Until I'm about to try it, I think a person might be into it.4. Layout for assembly: a. I found a 2x4 that mounts on one side and figured out what height I want. b. Use the bubble level and the distance between the two set screws to make a small mark on the wall. c. I took the block, turned it over and made a vertical mark where the set screws were. You now have a horizontal line and the correct spacing. i.e. Using this mark place the center of the mounting plate on top and mark the screw locations in the center of the holes above and below center ie Install the fitting in these holes (or drill and install screws in the 2 x 4 holes) then install the plate.f. Mount the unit and tighten the set screw (which is awkward due to the fitting used). I have already made three devices this way and it is fast, reliable and fast.