Review on 🔥 Enhance Ignition Performance with the OEMTOOLS 25069 Adjustable Spark Tester! by Robert Demissie

This is the cheapest crap I've ever seen. First, the tip doesn't stay in the plastic at all. Tilt it and the pen falls out! I got it to work by inserting locking rings in grooves above and below the plastic to hold it in place, but found the screw on the brass metal cap was too small for regular spark plug boots. OK. So I unscrewed it and unscrewed the spark plug cap. It worked once until the locking rings broke. So I sent it back for an exchange and they sent me a second, equally defective product. Also, the alligator clip is spot welded to the set screw. The spot where the spot weld is is made of very thin metal, and turning the screw will inevitably bend the clamp. It's easy to see that the clip breaks after a few iterations. In addition, the instruction card, which is attached to the blister pack in such a way that it cannot be removed without destroying the full instruction text, suggests setting the regulator to "SE" to test small engine ignition systems. The only problem is that there is no "SE" setting on the scale. Finally, you will NOT receive the main photo of the tester. What you get is the device shown in the rest of the photos. Scale, square body, not rounded, without plastic coating on the tip of the candle. In fact, if you look back at the first photo, which has the setting "SE" on the dial, it's almost as if the instructions were printed. for THIS model and it was replaced with this cheaper knockoff crap.