Review on 🔧 NANPU Pressure Regulator Lubricator Separator: Optimize Your Pneumatic System Performance by Neil Biondo

Media could not be loaded. I ordered this on Deal Day Revain. I thought it would be a lot. Wow, I was wrong. It was a failure from the start. It arrived without the plug and tape. I contacted Revain and they sent me a replacement. The first returned, the second came quickly. I installed it and started testing. I hooked it up to a Craftsman 1.5hp 3.8cc. feet per minute at 90 psi on a 26 gallon tank. My compressor was set at 120psi. Nanpu was set at 100psi. That worked for a good 20 minutes. Tried it with different tools. It turned out to be smeared. And suddenly a loud air-seer began to escape from it. I dropped everything and ran to my workshop, where I waited for a loud bang, but the noise continued. I pulled out my camera to record what it was doing and found the top plastic adjustment cap had popped out and you could see the gasket and air was being pushed out the side. I turned off the compressor. I removed the lubricator and put the cap back on, but as soon as I reconnected everything the cap popped back out and air started escaping.