Review on 🚗 Enhance Your Carriage with Befenybay's Modular Aluminum Upgrade by Jeremy Gulledge

Ender 3 Pro - SKR v1.4Turbo Overall this Y-carriage worked very well. I like doing less to level the bed. What I did not like, however, is that there are no indications. I understand 3D printing is kind of a DIY sport, but even a little map with a few tips would be great. So I'll share what I learned. Orientation isn't that important, you either have 2 wheels on the right and 1 on the left, or you have 2 wheels on the left and 1 on the right. If you're using clipper and the SCREWS_TILT_CALCULATE command, I recommend setting screw position 1 as the one-point side of the bed. Then 2 and 3 as side with 2 wheels. This will make the one wheel side permanent and give you more control over the alignment on the two wheel side. Also, don't forget to check the Y limit switch after replacing the carriage. switch the end stop forward about 15mm, then set the Y axis MAX in the firmware. Otherwise everything is great. Just a little extra effort could have turned this into an easy 5 star review. It wouldn't stop me from buying another one even if I needed it.