Review on TNP 10ft IR Emitter Extension Cable - 3.5mm Jack Infrared Red Transmitter Blaster Blink 🔴 Eye Wire Cord | Compatible with IR Repeater Extender System Kit, Xbox One (1 IR Eye Emitter) by Holly Robinson

I have an old but very reliable Niles control unit with a connection point but I need 2 indicators. This item corresponds to the invoice. The length of the cord was more than enough for my needs, and I suspect for most needs. My only criticism is that the wires (conductors) were very, very thin. I had to cut off the end of the connector to connect the cable to my Niles. It turned out that I had to remove about 1 inch from each pin and then fold them several times (leads + and -) to ensure a secure connection on Nile. You also need to be careful when removing the emitter extension. Cable from a plastic bag, otherwise you can throw it on very small and non-obvious sticky pads, although the word pad is too broad a description, the pads are a bit difficult to put on the emitter heads, especially if you don't have thin fingers! Radiators work well.