Review on Magnetic Bit Holder Extension Construction by Deandre Kamaludin

I ordered these a few months ago and wish I had fully tested them sooner because if I did I would return them in a heartbeat. I used to use various 1/4" bits to drive in and remove 1/4" hex Tapcon screws and finally got around to getting the plywood from one of last year's hurricanes. The 2" nozzle fell off after less than a dozen screws! I was glad I didn't collect plywood when I was hit by a category 4 or 5 hurricane while testing! A few days later I had to use a Phillips screwdriver. The 2" bit mentioned above actually worked great with screwdriver bits in the past, but was ruined when it was removed from the Tapcons. A little doesn't fit. No problem - I put in a 4" bit and thought I was done. Socket that this kit should replace and use. As two parts failed from this kit, one of which could have been fatal, I cannot recommend this product. I'll look elsewhere for a better install (and test!).