Review on GZBSIM Puller Suction Handle Lifter by Thunder Ballman

I had a quarter dent, maybe a little more, on the flat part of a car door. There were no scratches or paint chips. I managed to vacuum out most of the dents. I started by pouring hot water with steam (not quite boiling) over the dented door before using the suction cup, I did this to make the metal more flexible; it was kind of nerve wracking. I then used a suction cup to remove the dents and used a pulling motion like a toilet plunger a few times, but much slower. Sometimes I pulled the plunger so hard it looked like it was going to pop out; I did it on purpose. It took several tries before I got a very small dot, 1/4 inch. After that I used a dent remover and a set of glue because the piston was too big for a dent that size. The car door now looks much better, it remains only to look for a small defect. It's so small that you don't even feel it when you run your hand over it. At the same time, the paint remained intact, without scratches and chips. You have to look for imperfection but being a perfectionist it still drives me crazy. Also, it's a little scary to play around with the body unless you're a pro.