Review on Bushwacker 14001 Black Trail Armor Rear Corners for 1997-2006 Jeep Wrangler 2-Door: Perfect Fit with Pocket Style Flares, Pair by Dewitt Graham

This is a great kit if you are using it to cover up corner stains or just want to change the overall look. Installation is quick, but I'll go through some of the issues you might run into: 1. Make sure you're buying a kit that fits standard or Bushwacker fenders. They are shaped differently and will not line up properly with wrong wings. 2.) The wiring harness that connects the tail light on the passenger side is significantly shorter than the one on the driver's side, so not long enough to thread through the hole and disconnect. You have to access it under the car, which is easy; At the end of the wheel arch there is a plastic or rubber panel with a flap from which you can remove and unfasten the seat belt. Easy but does not require mud as you must lie on your back unless you have a relatively high instep. 3.) Wash corners and dry completely before applying. 4.) Before removing any layer of tape, do an alignment check to get an idea. From there, line up the holes first before pressing as auto tape is very sticky and will temporarily stick together. The driver's side is more difficult to align, on the side you also have holes for the gas cap. I had success doing the gas cap first at home and then aligning the tail light and license plate bracket. 5.) The scope of delivery includes clamp adapters for license plate screws. Make sure they're in the box before you even start. Before and after photos included. i really like it The rear door armor is made of a durable crest.