Review on 📷 MEIJIA Waterproof Portable Equipment Hard Case with Foam - Elegant Black, Fits Drones, Camera, Lens - Dimensions: 16.26x8.66x13.39 inches by Christopher Morgan

No complaints so far. I ordered this for small photo gear, action cameras and accessories. The burst foam is designed so you can layer small items or take out all layers for a larger item like a drone. It consists of three 3-1/4" thick peel layers. A 3/8" hard layer for the bottom. The foam cover is 1-3/4" thick. The locks have a good solid latch, but be aware that they cannot snag on anything or open as they do not have a secondary latching mechanism like my Nanuk 935 does was the case. , tied it to a weight and loaded it into the 5 foot end of my pool, the water temp was 80 degrees. A few hours later I pulled it out and found ZERO water infiltration as expected. Now it's getting normal never fully submerged in water.as it naturally floats when locked and the pressure valve secured but I wanted to know that it would not damage my expensive equipment.These cases require regular maintenance, inspect and clean the cap seal and o- Ring on discharge valve. Lubricate or replace as needed. I use o-ring lube on the cap seal and occasionally. To prevent premature tearing, this does not mean that s you should use them as they typically last for many years without maintenance. This is a good basic case and should last for many years even with abuse. Hope this helps, thanks!