Review on Enhanced 5 inch 800480 Resistive Touch Screen for Raspberry Pi: HDMI Interface, Raspbian Compatible, Ideal Video & Photo Display Module by XYGStudy by Pressure Cook

Works great on Windows 10 IoT on RP2 B with HDMI input. I haven't tried the 26-pin GPIO header yet. Just had to make a few minor changes to the config.txt. I also rotated the screen 90 degrees clockwise, no problem. Haven't tried to get the touch to work yet. Several lines of the default Win IoT splash screen are cropped, which is to be expected since this is a static layout - there is no scaling on this display. Mounting holes: 115x84mm. smaller than the width. Here are the 3 lines I added to config.txt along with some comments. It might be better to just start with that before connecting the display. If you have a problem, just uncomment these lines and reconnect your larger HDMI monitor that you started with. Good luck#hdmi_cvt=[width][height][frame rate][aspect ratio][borders][interlace]#width width in pixels#height height in pixels#frame rate frame rate in Hz#aspect ratio 1=4:3, 2=14 :9, 3=16:9, 4=5:4, 5=16:10, 6=15:9 7=21:9 8=64:27#margins 0=margins disabled, 1=margins enabled # interlaced 0 = progressive, 1 = interlaced # rb 0 = normal, 1 = reduced dimming # Added for 800 x 480 LCD panels (works for my Adafruit 5" and XYG 5" hdmi_mode = 87hdmi_cvt 800 480 60 6 0 0 0# portrait mode , rotate 90 degrees clockwise esdisplay_rotate=1