Header banner
Revain logoHome Page
Scott Channell photo
1 Level
1332 Review
62 Karma

Review on HGC Tightening Fixture Holder Machine Cutting Tools by Scott Channell

Revainrating 4 out of 5

Unbelievable price

The floor was not flat. Milled 0.03" to basically clean it up. The holes and edges are plasma cut and very hard! I drilled hole patterns to match the various slots on my router table. The tool holder rests on a flat surface and touches the cone of the Device not .JFYI.

Pros
  • Very good price
Cons
  • Unbelievable price