Review on HICTOP Thermistors Sensor Reprap Printer by Reed Nuttbrock

Arrived VERY well packaged. All probes are perfectly coiled with a single elastic band holding them together. I pulled what I needed out of the box, not confused at all. While probably not needed, it arrived in one of those anti-static gray clear plastic bags. I received this because my factory Ender 4 temp sensor failed (accidentally started getting a "Mintemp error"). Exacto knife to cut off the old sensor in the middle of my heated bed, grabbed a pair of needle nose pliers to remove the old sensor, then popped the new sensor into this hole (maybe I'm not sure about filling this hole target). with thermal paste.) I just taped it in place with all weather high temp tape and also used the same tape on the bottom of the heatbed to hold the wires in place, then zipped the wire along the heatbed tied existing wiring. Slightly longer than shorter. You can always wrap it extra and zip it up if needed (but it's not very long so it's not really needed).