HICTOP Thermistors Sensor Reprap Printer Review

This is not plug and play for Creality CR 10S pro V2 printer. The connector does not have a spring latch like the original and the two protruding leads in this area must be trimmed flush to allow the connector to fit the socket on the circuit board. Without the spring clip, the connector may come loose. A speck of hot glue between a fork and another fork will prevent this. Also, once plugged in, the temperature gauge was as close or as close as possible to the original. Very happy to have it…

I bought these thermistors for my Prusa MK2. I bought a pack of five because this is the second time I've had to replace the bed thermistor. I received the product quickly. They were neatly tied but still together. No separation problems. I installed it on my Prusa and it works great. It gives the exact temperature of the bed according to my infrared thermometer I. One problem is that it's not a replacement for the MK2. Prusa uses DuPont style connectors on this model and the ones I ordered…

Arrived VERY well packaged. All probes are perfectly coiled with a single elastic band holding them together. I pulled what I needed out of the box, not confused at all. While probably not needed, it arrived in one of those anti-static gray clear plastic bags. I received this because my factory Ender 4 temp sensor failed (accidentally started getting a "Mintemp error"). Exacto knife to cut off the old sensor in the middle of my heated bed, grabbed a pair of needle nose pliers to remove the old…