Review on HICTOP Thermistors Sensor Reprap Printer by Cory Mosley

Name: HICTOP Thermistors Sensor Reprap Printer
Item: HICTOP Thermistors Sensor Reprap Printer
Rating: 5

August 26, 2022

But not working directly

This is not plug and play for Creality CR 10S pro V2 printer. The connector does not have a spring latch like the original and the two protruding leads in this area must be trimmed flush to allow the connector to fit the socket on the circuit board. Without the spring clip, the connector may come loose. A speck of hot glue between a fork and another fork will prevent this. Also, once plugged in, the temperature gauge was as close or as close as possible to the original. Very happy to have it printed again, would look elsewhere or go with real creativity.

Pros

Recommended thermistor setting: R25℃=100K B25/50=3950K± 1%

Cons

Can't remember

New products

Comments (0)

Please, sign in to write a comment

Top products in 🖨️ 3D Printer Parts & Accessories

10Mm X 11Mm Black Plastic Open Type Cable Wire Carrier Drag Chain Towline R18 For 3D Printer And CNC Machines - 1 Meter Length

5

7 Review

BIGTREETECH SKR 3 EZ Control Board 32Bit New Upgrade Silent Board Support EZ2209/ EZ5160/ EZ2130 Stepper Driver Compatible TFT Series Touch Screen, DIY For Most FDM 3D Printer (With 5PCS EZ2209)

1.94

7 Review

Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards