Review on DT-5301 R loop phase-to-zero and short-circuit current meter CEM by Bogdan Lambev ᠌
The product did not disappoint, the quality pleases.
The device seems to measure the voltage between the phase and zero probes, and measure the current between the phase and ground probes. It seems like the PUE requires measuring exactly the current of a single-phase short circuit to a grounded case (ground). But, if you have a PEN conductor, then both probes (zero and ground) should be connected to it. It's not convenient to say the least. It would be better to add some kind of switch. And, in general, the device is worthy.
- Budget option for amateurs and semi-professionals.
- No instruction manual. There is no way to normally take measurements in the TN-C system, there are no problems with TN-S.
New products
Comments (0)
Top products in 📊 Diagnostic, Test & Measurement Tools
Vgate ICar Pro Bluetooth 3.0 OBD2 Code Reader OBDII Scanner Scan Tool Car Fault Diagnostic Check Engine Light For Torque Android
22 Review
Autel AP200H OBD2 Scanner Dongle - Wireless Bluetooth Code Reader with Health Status Reports - Diagnostic Tool for Engine, Transmission, ABS, SRS - OLS/BMS Resets - All Vehicles (Android/iOS)
11 Review
Upgrade Your Car Diagnostics With 16 Pin OBD2 Extension Cable Splitter - Male To Dual Female Y Cable - 50CM
17 Review
Autoscanner for car diagnostics Rokodil ScanX Pro, OBD2 scanner
29 Review
