This is the worst Raspberry Pi case I have ever used. The layers of plastic are so brittle that if you tighten the fastener even a little harder than "by hand" (e.g. just with your fingers), the plastic will tear somewhere. And as more layers are added, it's likely to crack somewhere, even with "finger tightening". The acrylic used is too thin and too brittle. Save hours of wasted time and pay an extra $20 for a properly assembled case.
Gikfun Screw Shield Expansion Board: Дополнение Arduino UNO R3 с помощью EK7007 Add-On
11 Review
Набор LAFVIN Super Starter для Arduino R3 Mega2560 Mega328 Nano с подробным руководством - совместим с Arduino IDE
11 Review
Vilros Raspberry Pi 4 4GB Полный стартовый комплект - Черный вентилируемый алюминиевый корпус для высоконагруженных задач
12 Review
RЕXQualis комплексный стартовый набор с Arduino MEGA 2560 и подробным руководством совместимостью с Arduino IDE
11 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review