Review on 🔧 Pair of Adjustable Carbon Fiber Splitter Strut Rods - 15cm Front Lip Bumper Splitter Tie Support Bars (Carbon, 8"-11") by William Wiley

Used shaft to install a Vega Motorworks splitter in my Fiesta ST. They didn't hold tight, made occasional noises (e.g. clicking from a loose fastener), and actually did excessive damage to my splitter. This is because the filament sticking out at the bottom added too much length at the bottom, and when my machine scraped those filaments underneath, they bent the bottom splitter bar mount since the contact point they have with the splitter is small (bending a small part of my splitter). I have since fixed everything but of course I bought some FTR rods instead. They were difficult to put back on due to the poor quality of the hardware (and the silly design where the threads stick out which does a lot of damage over time and makes them difficult to thread onto the nuts). save your money; cheap splitters will not fit.