Review on 🔧 Optimized Positioning for Aluminium Woodworking Carpenter Clamping by Matthew Aiono

Ordered these after seeing the woodpecker version. I figured I'd risk her for the price. I will say that I am pleasantly surprised. The measurement markings on the side are about 1/32 inch smaller than my DelVe. They are also all square. They work with the fence clips I received from MilesCraft. Although the clamps don't go through the holes on the square. The clamp can be used if the hole on the other side of the square is larger, just remember it doesn't go all the way through the hole. The slotted area allows the clamp to pass completely. I found that there were areas on each square where the coating had been removed and bare aluminum was visible. It was only found in the holes of the course. See photos for further explanations. In general they fit me and the most important thing is that they are square. Yes, the rulers on the side are good, but I wouldn't use them if you're working precisely on the part. Most carpenters find the angles fairly accurate.