Not hardening which was probably a good thing as it's a bit small and the teeth barely make contact with the flywheel. The only reason I gave it 2 runs is that it got the job done because I used a crank envelope and a bar tool to fine tune the TDC. The teeth would probably wear out if I made a full revolution with this bar tool.
🔧 GearWrench Universal Pulley Holder - Versatile 15-Inch Tool for Hassle-Free Repair
9 Review
💪 Lisle 39000 Pulley Puller: The Ultimate Tool for Convenient Pulley Removal
9 Review
Complete Ford 4.6L/5.4L/6.8L 3V Engines Repair Tools Set - Valve Spring Compressor, Crankshaft Positioning Tool, Cam Phaser Holding Tool, Timing Chain Locking Wedge with Crankshaft Pulley Bolt
10 Review
BETOOLL Camshaft Tensioning Alignment Chevrolet
9 Review