Review on 🎵 Goliton Pioneer 3.5MM AUX Input Audio Cable for MP3 CD-RB10 CD-RB20 iB100 IP-Bus 12-PIN by Quintin Boner

This chord does exactly what it says. Plug it into the blue AUX port on the back of your Pioneer receiver (in my case a Pioneer mosfet eeq 50wx4) and then plug the other end into the headphone jack on your iPod, MP3 player. Three hints: 1.) To turn on AUX, turn off the receiver by pressing and holding "Source" and then press and hold the "Function" button until the time settings are turned on. Hold "Function" until you reach AUX, which will be off, press the up arrow to turn it on and click "Source". Now you can press "Source" until AUX appears as an option. Note 2.) Use the SLA setting under the "Audio" button to maximize the volume for AUX as it's usually a weak iPod/MP3 single that needs some boosting. Note 3.) At first I used my hand to push the connector in as hard as I could and got no response. After reading a bit more on the internet I realized that the cable should be inserted very firmly and fully so I used a small hammer to pound it firmly and now it works perfectly!