Review on 🔥 Assembled Extruder Printer: Optimal Heating Ensuring Effective Performance by Deshaun Fisher

After being attacked by a giant FDM blob, my hotend has never been the same. I'm still not sure how many things went wrong and I was running out of patience to track down every single issue. I just couldn't get quality printing. It took about 40 minutes to replace while doing other things, it would go faster if I was focused. You'll need a couple of zip ties to plug everything back in and you should take a picture of where the existing cables are before you start removing things, or take a look at one from this review. The two red wires from the cartridge heater, the blue/yellow and dual white molex connectors, and the black/red pair below come off the shell and need to be reattached. filling level and the printer works again. I'm printing PLA at 215 that I've previously printed at 205, but I'm not sure if this is due to the thermistor calibration (so it's not really a temperature change) or just an older batch. It's actually tempting to just buy another one to keep on hand. I'm sure I could assemble the parts cheaper if you don't value my time, but it's nice to know it works.