Review on Creality Upgraded Extruder with Capricorn Pneumatic System by Gage Lawson

I may have had a tube that was too long before, not now, but this Bowden tube is short. The "kit" comes in a plain yellow envelope, without instructions and only with many loose parts. Wiring is set up at the hot end, so that's good. No certificate is supplied as stated in the product description. I hope this hose is long enough. I can't rate the specs; I haven't installed it yet. -- Update -- I finally installed it and am typing with hotend with great success. bowden cable; as short as it is, it's wonderful. I just didn't know how long it would take I guess. Installation is fairly easy - you just need to reach under the printer to remove the casing around the control board. Plugs and free red wires can be plugged in without any problems. If you have good lighting and are ready to just jump in, the instructions aren't really needed, although you'll end up either cutting the wrap of wire or clipping the end of the plug from the connector. old hot-end cable to remove it completely. It's a pity that there is no exchangeable wire winding in this "kit"! That would be almost perfect.