Review on 🎮 Enhance Your PC Setup with EZDIY-FAB Vertical Graphics Card Holder Bracket - White by Delos Rodeo

Well it was a great purchase. This mount gave me a lot of placement options. I chose to install a support bracket on the front of the mounting plate, which gave me room behind the GPU to stow the installed USB 3.0 PCIe card. (You can see the space in the second photo.) Note that this will move your fans closer to the side panel and may restrict airflow. In my case, there's enough depth to support a decent amount of real estate, and the pace matches the GPU's default horizontal position. It also helps that the case is an open frame design so the airflow is amazing. I have a heatsink on the front of the case in a push/pull configuration and the ability to move the support bracket back and forth allowed me to have plenty of room. to install the GPU in its place without removing the exhaust fans. Keep in mind that my case is shaped differently (as you can see in the photo) so the heatsink is angled rather than vertical and straight. GPUs come in different lengths and mine is very long for two fans. That's pretty close to the length of 3 compartments. PC cases also come in a variety of lengths, so the ability to move the mounting bracket can help you install your GPU and monitor cables. ARGB was a nice touch. It was easy enough to connect to my Razer Chroma hub and sync to the lights. Diffusion is good but you can see individual LEDs. Looks good but just take note. The entire rig is a bit heavy and will move from side to side when pushed, so multiple support options are included. They have some foam pads and 2 hefty metal L-brackets that you twist together to create support and screw into a slot so they can be adjusted to the length of the support bracket. It would be very solid if mounted with a bracket, but my power supply was directly under the GPU and gluing one of the foam pieces did the job of supporting the back of the GPU. The riser is flexible and I had no problems. Install it in a slot on the motherboard. I was very happy to see that the through holes on the board are plated so I don't have to worry about the screws shorting out and then catching fire. #NZXT My GPU snapped onto the stand and I screwed it to the bracket using the thumbscrews that came with it. I ran some tests and the GPU performance didn't change. Only time will tell how long it lasts but it looks good and the quality is very good. Overall I am very happy with the installation. The instructions were very easy to understand. I just looked at the photos and followed them. I really don't even remember reading any of the words, the pictures were perfectly explained. To wrap this up, I suggest trying this GPU mount. For $35 I think this is a great option and can give amazing results.