Review on Enhanced Low Friction Dust 🚵 Wiper Kit for Fox Racing Shox 32mm by Jeremiah Small

I have installed 32mm Fox Dust wipers (#830-00-944 B) on a 2010 140mm Fox RL fork with no issues. It took me about 3-4 minutes per foot to carefully align the gaskets with the Unior gasket setting tool. I left the seals flush about 1/32" over (see inset drawings). I placed the fork on a rubber mat with a board underneath and hit the mortise guide with a plastic mallet. used no more than 5 pounds of shock thrust. Earlier this week got it I have installed two sets of SKF flange seals on two other forks.While the SKF seals (green) are a bit easier to install (due to the flange), I wouldn't hesitate to buy and install these Fox seals in the future.One caveat: Be careful not to overdrive the gaskets (i.e. under-flush) you've over-driven them In addition, less effort is required to continue installing gaskets after they've started compared to that initial effort required to start them Alignment issues Note: Fourth image shows the Unior Guide Tool I gave the scrapers 4 stars. due to the fact that they are not reliable to install.