Failed to load media. The chisel cut well, but the bearing was in poor condition. At least I thought it was a camp. It wasn't in the middle, leaving a terribly wavy cut. I threw it in a metal lathe and put a gauge on it and the shaft the bearing rides on was .034". I would consider 0.002 inch runout to be the most acceptable minimum. But 0.034 inches. It's terrible. That's why he left such a bad cut. I wouldn't buy it again and spend a little more money for a usable part.
Multitool pliers GANZO G202 black
12 Review
Enhance Woodworking Precision with Roundover Milling Rounding Edge Forming Tool
11 Review
High-Performance Whiteside Router Bits UD2102 Compression for Precise Woodworking
10 Review
Ultimate Guide to KOWOOD Router Pieces for Woodwork Beginners
11 Review