Review on 🔧 Precision Variable 7X14 Inch BestEquip 50-2500 by Junrey Jewel

Well, it used to be…. That's pretty much the same compliment I'm about to give. The center is far from the center. The knobs we broke (okay, I'm a locksmith, no problem) went to put the lathe on the table and there were two broken taps in both rear legrest castings. Gear changing is terrible. Low RPM has nothing to do with vibration, so I wouldn't recommend anything less than max RPM (probably cheap bearings). The dead man's shank is very difficult to use as there is a nut hanging from each support of the center cast so someone didn't get their calculations right... Yes I'll keep it and make my own parts to improve it, but it's a pretty terrible value. for money.