Review on 🔒 6950P Billet Fuel Door - Enhanced Sales Optimization by Curtis Kincade

This is a very good product and if I followed the instructions the installation time would have been around 30-45 minutes. Read the manual a few times, your truck will be explained and will work fine. OK, the first thing I did to get the RIGHT one better centered was I used a small metal file with a rat's tail to slightly enlarge the factory holes in the RIGHT truck. This way you can move your device to a cheaper location. I then removed the gas cap (Big Hands) so I could put the small washer onto the stud first, then the remaining washers and nut, and then tighten the nut with an 8-9mm open end wrench. The two very long screws I found were not needed to adjust the right hand pressure. The shorter one worked fine, this adjustment is important to keep the billet frame in contact with the bed. DO NOT throw small washers or nuts, they are very difficult to get out, stainless steel so the magnet will not work. That's it, great product and looks stunning.