Review on VViViD Dry Carbon Fibre Detailing Vinyl Wrap Tape 2 Inch X 20Ft Roll DIY (Gunmetal Grey) by Unm Weil

Product instructions would be very helpful. Product arrived in good condition, no edge issues as noted in other reviews, looks good. But without the details of "MANUFACTURER" it remains to rely on suggestions that others have left in reviews and / or YouTube videos. Still wondering how to deal with curves in the finish as recommended by the MANUFACTURER? What are the MANUFACTURER's recommended bending limits? Should I use a hair dryer OR a heat gun as recommended by the MANUFACTURER? Does it have to be heated up immediately after installation or can it be done later as recommended by the MANUFACTURER? In hindsight I applied heat after the job was done and it seemed like the glue had evaporated from the edges a few days before deciding to apply heat and so the edges aren't sticking, probably to be expected but installation instructions The MANUFACTURER should have made these recommendations. No offense to those who leave guides in their reviews or YouTubers, but sometimes these recommendations can vary like day and night, so the MANUFACTURER'S guide will provide clarity. Now I'm stuck on a project that looks good from a distance but doesn't look so good up close, with edges peeling, cuts on the curves, and I'm afraid to pull it off for fear of making a gooey mess on the could have been avoided following the MANUFACTURER's instructions. If I were to try this again I would choose a wider band so I don't have cuts/stretches at the creases.