Honestly it's not a problem that it's not flat, I just run it on a cutter. If you don't have access to a car I wouldn't buy it. This will likely result in a vacuum leak if you don't mill both sides flat, unless you're lucky and your side isn't straight. Unlikely, judging by other reviews.
π§ Exhaust Flange Repair Kit - Walker 36132
9 Review
π New Edelbrock 1405 Performer 4-Barrel Carburetor with Manual Choke, 600 CFM Square Bore and Air Valve Secondary
9 Review
Exhaust fan Soler & Palau SILENT-100 CZ, Silver 8 W
41 Review
Exhaust fan Soler & Palau SILENT-100 CZ, gold 8 W
29 Review