Review on 🚗 High-Powered Xenon White 15-SMD-5730 LED Upgrade Replacement Bulbs for Car Backup Reverse Lights - iJDMTOY 7440 7441 7444 T20 by Pop Henneghan

I used these to replace the reverse lights in my 2016 Mazda 6 GT. First I made sure the cavity would accommodate the new lightbulb. The LED is easily 2 1/2 times the length of the 7440 bulb it replaces. no problem. Pulled out 6 clips on each side of the inside of the trunk to access the lamp base. did a side first to see the difference. The LED was very white, a little bit blue compared to the original which looked quite yellow in comparison. the LED looked brighter but it wasn't night yet so I haven't seen it there yet. definitely a nice change. Mazda should have done it for the extra few dollars it would have cost them. All interior lights are LED, why not reverse lights? UPDATE I almost forgot when I hit the REAR ENTRANCE while pulling into my garage last night. WOWEE-ZOWEE these puppies are BRIGHT. They lit up the entire garage. I had a different thought about her. The 7440 bulb they replaced was too easy to remove and install. Since they are bigger and heavier, I might put some silicone sealant on them where the plastic connects to the connector. not inside, only outside. and will use white or almond so I can see if I need to remove it. I don't want to take a bumpy road so they can find themselves and jump around. and because the connection is so easy, i really see it as an opportunity.