Review on Cooler Master MasterAccessory ARGB GPU Support Bracket - Enhanced with Edge-Lit ARGB Tempered Glass, Universally Compatible GPU Bracket with Adjustable Orientations by Ryan Judy

I used this to support my RTX3080 in my case. I don't like RGB, but this was the simplest I could quickly find. The base is heavy and has a rubber bottom. It seems to be magnetized if I'm not mistaken. It really stays in place. Solid, well made, well finished edges. The actual support is pressed against the vertical transparent element, but in ONLY two orientations (front to back on the right side or right to left on the back). The key here is to have the horizontal support mounted on the RIGHT side, not tipping over, and still sticking out about 1/3 inch. I feel like this is a serious design flaw as the whole point of supporting a graphics card is for long and heavy graphics cards. As a result, there is usually not much space on the right side of the case, especially for case fans or coolers. The horizontal bracket should be mounted on the LEFT side of the transparent vertical part or in the middle so you can mount this thing as close to the right side of the case as possible. In my case, the disk trays are on the bottom, so the base of this thing doesn't quite fit. The RGB lighting cable means it doesn't quite fit. I had to tilt it to fit in there. Not the best design overall, but it does the job. The RGB cable is long enough to reach your mobile device or RGB port.