If you are installing an oil pressure sensor on a GM 2.4L Twin Cam engine and want to keep it Factory sensor, then it works perfectly. You will need another adapter to fit the aftermarket sensor into the top port of this unit. Put teflon tape on all threads and use an 18mm wrench to turn the square part of the block. Tilt the top connector toward the power steering pump to disconnect the ignition module connector.
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Vacuum cleaner Dreame V9 Global, white
145 Review