Review on Fiberfly Gimbal Bearing Puller Remover Tools & Equipment by Robert Maysey

Worked exactly as it should. I used outdrive for Alpha One Generation 2. First, the plate was misplaced. The middle hole was on the wrong side. The hole is for the output gear oil port. Insert into the bearing, slide the T-handle shaft in as far as it will go to secure it in the bearing. Use a 1 1/18 wrench to unscrew the bearing. Less than 10 minutes with already departure. Before ordering I tried the slide hammer but to no avail. The hardest part was removing the bearing from the tool. I used a hose clamp to squeeze the end and the bearing fell off immediately.