Review on 🚀 Enhance Performance with CDHPOWER Off Set Air Long Intake (40mm) for Gas Motorized Bicycle by Timothy Wall

Well the intake manifold didn't fit my Seeutek 80cc engine but that's my fault as the 40mm size was clearly stated in the title. My engine is 32mm. If it were the right width, there are still some problems. First, the bracket is too flat to use the button nuts that come on the motor, so regular thru nuts are required, which are not included. Also, the welding wasn't very good and there are bumpy areas on the mating surface that could probably cause a bad seal causing an intake leak. I'm sure not everyone will have this problem, but the one I got looked sloppy.