Review on 🌟 FLSUN Permanent Automatic Leveling 255mmx260mm: Advanced Precision & Convenience Combined by Jerardo Phi

Be I've only had it a few weeks and am just finishing my first print. I'll say I'm impressed. Test prints are useless. I received the machine very well packaged with colored instructions inside and on the micro SD card. I assembled it in just over 30 minutes and was ready to go to zero. I was in a hurry with my Ender 3 experience, so I waited for feedback from my colleague in the writing community. I had to unscrew the bottom plate and switch the power to 110 and check all the pre-installed screws for tightness. I had no problems with loose screws or over-twisted lines. The belt tension could have had better guidance. I've been told 2 things about this that I trust. tighten evenly, and that when you "pull" the cord like a rubber band, it makes a note. it has been repeated too many times to be nothing. Not as quiet as I've read in other reviews. Knocking and vibration are initially too strong. If (and when) I do it again I'll grease the inside of the bushings when reassembling. I feel like the pounding eased as the lube spread. I recommend buying TL Trowels to reduce vibration ($10-15 on Amazon) to reduce surface pressure issues. I am posting this experience on YouTube "Theory about Everything" and will update this review later. Currently 4 stars could be 5 stars when I find out wifi.update----9//20. PLA adhesion is definitely good, too good, or I had a broken glass platform. I removed the model from the platform and with it came a piece of glass from the platform. the FLSUN website is currently closed by the Chinese government. Printer does not knock I read reviews where this has happened and support replaced the bed. I hope I'm so lucky.