🌟 FLSUN Permanent Automatic Leveling 255mmx260mm: Advanced Precision & Convenience Combined Review

OK First off I can say it was packaged like sardines in a can. Under no circumstances would it be damaged during transport. The next task was to put everything together because I have a lot of experience with a 3D printer. If I were new to printing I would be lost. All 3 straps were twisted and I had to remove and redo them. To be healthy and a full grown man. I haven't seen the video or the book, I'm sure it would help. Then, once together, it was impossible for about an hour to align z and…

Be I've only had it a few weeks and am just finishing my first print. I'll say I'm impressed. Test prints are useless. I received the machine very well packaged with colored instructions inside and on the micro SD card. I assembled it in just over 30 minutes and was ready to go to zero. I was in a hurry with my Ender 3 experience, so I waited for feedback from my colleague in the writing community. I had to unscrew the bottom plate and switch the power to 110 and check all the pre-installed…

Immediately after the printer arrived I received an email explaining that this printer model is new to the US and that I have the base voltage of 230 V would need to set to 110V. Since I've already assembled, tested and discovered this myself, I've written it off as "not ready for the US market". However, this delta has some advantages and disadvantages; Pros: 1) HIGH print capacity - my model prints models 300mm and taller, 2) FAST - compared to my i3 Cartesian printers, this thing flies, 3)…